Jaw crushers should be fed a consistent rate of feed that will result in the crushing chamber being kept full at all times. This will result in more stone-on-stone crushing, reducing the wear on the (jaw die) manganese wear plates, creating a more cubical product, and result in more even wear over the length of the jaw die

Generally all material smaller than the discharge gap should be removed (scalped) prior to being fed into the jaw crusher. This will increase the tons per hour of total production by the plant, and reduce wear on the jaw dies. It will also reduce fines production and increase cubical product.

A jaw crusher should not be sized to the maximum size rock that might be fed to the plant, but a size that will handle 95-98% of the material that might be fed to the jaw. Buying to the maximum size of rock that might be fed the jaw will result in buying a jaw crusher that will be under-utilized, difficult to keep choke-fed, cost more than necessary, and have a much higher operating cost. It will cost less to install grizzly bars over the feed hopper to remove the oversize rocks than to buy an over-sized jaw crusher. They can then be manually broken, sold as rip-rap or erosion control or landscaping boulders.

Jaw crushers are typically used as primary crushers, or the first step in the process of reducing rock. They crush primarily by using compression. The rock is dropped between two rigid pieces of metal, one of which then moves inwards towards the rock, and the rock is crushed because it has a lower breaking point than the opposing metal piece.

Jaw crusher main Features and Advantages:

1) High efficiency and low operation cost
2) Flexible capacity
3) Simple structure and easy to operate
4) Over loading protection
5) Easy replacement of wearing parts
6) Long service life
7) High reliability
8) Wide ranges of choices
9) Alternative ordinary and hydraulic types

Jaw crusher Parameter:

If there is change of the above specification, it subjects to the newest products' specifications.